In this category, you can find all products from the offer that are on sale.
Showing 49–61 of 61 resultsSorted by average rating
This small, practical, and portable USB soldering iron powered from PC, laptop, or portable batter is perfect for makers! It works over any USB port and the small tip makes it very precise. The tip also warms up very quickly, so you can start soldering around 15 seconds after the ignition. Soldering iron comes with a bracket, small amount of solder and a stand.
Of course, be careful while working with soldering iron. Iron’s tip is at temperature is 300-400 degrees Celsius.
• Power: 8W
• Input voltage: 5V
• Length: 16cm
We all know what HDMI cable is and we offer it because it’s required to connect Raspberry Pi with an external monitor. This is a classic male-male HDMI cable.
Length: 1m
JST (more precisely JST XH) connectors are today the most common connectors for rechargeable lithium batteries but are also used for many other applications where a fast, easy and convenient connection is required.
Male header at 90 degrees angle and pin spacing 2.54mm (0.1 ‘). 40-pin.
Comes in a pack of 5 pieces.
Isopropyl alcohol is an alcohol of high purity which can be found in almost every workshop. It is useful for cleaning printed circuit boards, because it evaporates quickly and allows the removal of greasy deposits (such as traces of flux/paste) and dirt. It is also used in 3D printer cleaners and all other applications where cleanliness is important. NOTE: it also has antibacterial properties.
• Frequency: 32.768kHz
• Crystal
Electromagnetic lock allows you to lock the door by a microcontroller or an external system. This one can hold up to 60kg with its electromagnet, which is just enough to when used with doors of the appropriate weight. Ideally, it should be used on smaller doors, windows and drawers. It is activated, that is “locked” when it is supplied current.
It consists of two parts, piece of an electromagnet and the metal. Comes with all necessary screws for installation.
This small sensor will measure the current that passes through his wire transformer and the information you get in return is in the form of a small stream. That small current will be measured as a voltage drop that is already built into this sensor. The sensor works on the principle of an open transformer. It’s not as complicated as it sounds. For more details, check out the datasheet.
Only one wire put through the hole!
Crystal (oscillator) is identical to one that uses a frequency of 8MHz, in HC49S (standard THT) packaging.
Micro-USB SMD connector for soldering to the printed circuit board. The same as it’s used to Croduino Nova, CP2102 USB to UART adapter.
Crystal (oscillator) with a frequency of 16MHz.
USB mini-b female connector for a printed circuit board (PCB). It’s identical to the one used on Croduino Basic.
CR1220 3V battery that we use in Croduino Damba.