Add-Ons
Add-Ons
24/7 lifetime customer and technical support
2-year Warranty -no questions asked
Comprehensive Documentation
Open-source everything
Made in EU
Designed and manufactured in Croatia.
2-year warranty
Standard EU 2-year warranty on all Soldered products.
Complimentary technical support
Our engineers answer your questions free of charge.
Arduino-compatible
Plug it into any Arduino board and start coding in minutes.
MicroPython-compatible
Drop the driver onto your MicroPython-ready board and run it, no compiling required.
Qwiic
Solderless Qwiic connector, chain it to any Qwiic board with a single cable.
LEGO-compatible
Mounting holes line up with LEGO spacing and peg size.
Description
This board reads SGX-4 series electrochemical gas cells. The LMP91000 analog front end biases the cell and turns its current into a voltage, a 16-bit ADS1115 ADC converts that voltage, and an ATtiny404 talks to both chips for you, so your microcontroller sees a single I2C device.
The LMP91000's bias, gain and load resistor are set over I2C, so the same board works with different cells. The libraries carry ready presets for CO, NO2, SO2, O3, NO, H2S, NH3 and Cl2 cells, and you can set every register yourself for other cells. An MCP1525 gives the front end a 2.5 V reference. The ADS1115's other three inputs, AIN1 to AIN3, are on a header for your own analog signals.
Connect the board with either of the two Qwiic connectors or the 2.54 mm headers. It runs from 3.3 V; there is no regulator, so the header and the Qwiic connectors share one 3.3 V supply. The default address is 0x30; the three DIP switches move it from 0x30 to 0x37, so up to eight boards share one bus. The front end's analog output VOUT and the ADC's ALERT pin are on the header too. There are libraries for Arduino and MicroPython, plus an ESP-IDF component and an ESPHome component.
Technical Specifications
- Analog front end: Texas Instruments LMP91000
- ADC: Texas Instruments ADS1115, 16-bit, 4 inputs
- Bridge MCU: Microchip ATtiny404 (factory firmware)
- Voltage reference: MCP1525, 2.5 V
- Gas cell: SGX-4 series electrochemical cell, 3-electrode
- Interface: I2C, address 0x30 (0x30 to 0x37 by switch)
- Supply: 3.3 V, no regulator; the Qwiic connectors share this supply
- Header pins: VOUT (analog out), ALERT, AIN1 to AIN3 (analog in)
- Connectors: 2x Qwiic, 2.54 mm headers
- Dimensions: 38 x 38 mm
- Mounting holes: 4x 3.2 mm