Shop

A classic CR2032 3V battery, used in some watches or remote controllers.

CR1220 3V battery that we use in Croduino Damba.

Standard USB A type connector for the Printed Circuit Board(PCB). It can be used as the USB connection, connection for the charger or something else.

Pushbutton is a small button that fits with the breadboard. It has two states: connected(ON – when the button is being pressed) and disconnected(OFF – when the button is not being pressed). It can be used, for example, as a switch. This pushbutton comes in Croduino for beginners set.

A photoresistor is a type of resistor that changes its resistance depending on a light that falls on it. They are super simple for making something that is needed to keep track of the amount of the light(for example, it turns the light on when it is dark).

Potentiometer with mutable resistance from 10k that corresponds with the breadboard. They can be used for various kinds of control, for example adjusting the intensity of LED lights. One of these is also in our Dasduino Beginner Kit.

Using this 8-bit shift register called 74HC595, you can increase the number of I/O(input/output) codes on your Dasduino/Arduino. Register itself uses 3 codes from the microcontroller, and in return it gives 8 I/O codes. The fact that you can connect a very large number of these registers and get a very large number of I/O codes by using only 3 codes from the microcontroller should not be neglected.

This transistor is also in our Dasduino Beginner Kit.

MOSFET N-channel transistor, with its characteristics, fits great with Dasduino/Arduino. With this transistor, you can control devices that need a great amount of current or great voltages through microcontrollers.

This transistor is also in our Croduino for beginners set.