Shop

A set of heat shrinks that insulate the connections between the wires when heated.

The set consists of:

• • 60 heat shrinks 40 mm long, 2 mm in diameter
• • 30 heat shrinks 40 mm long, 3 mm in diameter
• • 16 heat shrinks 40 mm long, 4 mm in diameter
• • 16 heat shrinks 40 mm long, 5 mm in diameter
• • 16 heat shrinks 40 mm long, 6 mm in diameter
• • 10 heat shrinks 40 mm long, 9 mm in diameter
• • 8 heat shrinks 40 mm long, 10 mm in diameter
• • 8 heat shrinks 40 mm long, 11 mm in diameter

A 7-segment display is a classic, frequently used and already familiar component. Size of the digit on the display is 0.56inch and the light it transmits is red. The display has a common anode.

Protoboard used for the permanent connection (also known as soldering) of electronic components. High quality, with solder mask on one side, as well as column and row markings.

• Dimensions: 7cm x 9cm

Protoboard used for the permanent connection (also known as soldering) of electronic components. High quality, with solder mask on one side, as well as column and row markings.

• Dimensions: 15cm x 9cm

A mini version of our larger membrane keyboard that will still be sufficient for projects that need slightly less input.

• The size of the upper part: xcm x xcm
• Cable lenght: 9cm, flexible
• Connector: 5-pin

This easyC cable exposes all the pins on the easyC connector. Using this cable, any easyC board can be connected to an experimental board or vice versa.

The WS2812B is a smart LED light source with an integrated control circuit and RGB diode. Unlike traditional RGB light sources, the WS2812B is much easier to operate since only one digital control signal is required.

ESP32-WROVER is a powerful microcontroller which has the possibility of wide application as it is possible to modify the processor clock and use its substantial memory. For these reasons, ESP32-WROVER can be used not only in conditions where low power consumption is required but also in situations where high speed is required to process large amounts of data.

The ESP32-WROVER comes with a PCB antenna and offers WiFi and Bluetooth 4.2 connectivity. The core of the module is the ESP32-D0WDQ6 chip. The operating frequency ranges from 80MHz up to 240MHz and the microcontroller can be used with 4MB of flash memory. The freeRTOS operating system drives the ESP32.

SoC: ESP32
Number of pins: 38
Number of GPIO pins: 32
Voltage: 2.3 V – 3.6 V, recommended: 3.3 V
Current: maximum 500 mA, average 80 mA
Operating temperature: -40 – 85 ° C
Chip: ESP32-D0WDQ6
Microprocessors: Xtensa 32-bit LX6
Flash: 4 MB
PSRAM: 8 MB
Dimensions: 18 x 31 x 3.30 mm

Classic male header with a pin spacing of 2.54mm (0.1″). The pin layout is 20 x 2.

5mm RGB LED diode in through-hole version with 4 pins. Each of those represents one color (-), while longest pin is common anode(common +) for all three colors.

• Voltage: 3.4V for blue and green, 2.3V for red
• Current: 20mA per color, total max. 60mA
• Diode size: 5mm, diffused
• Light angle: 25 degrees

This RF converter is used to connect coaxial cables. The converter has a male input on one side and a male output on the other.

This connector allows the connection of an antenna with a male SMA connector to a board at a 90-degree angle.

Classic current adapter from switching the american to european type connector.

• Dimensions: 25.5 x 30 x 14mm

This cabel switches your antenna with an SMA female connector to an N-type connector.

• Cable lenght: 1m

This Li-ion battery is small, light and durable! Through a standard JST 2mm female connector it will give you normal 3.7V that will power your projects whole day (and night). It also has a built-in system for protection from too high a voltage (prevents overcharging), too low a voltage and short circuit. That’s how it protects the battery and ensure a long lasting and safe environment for your projects!

Warning: This battery must be charged with special charger principle CC/CV – like the charger recommended under. Li-ion batteries are dangerous! Read our tutorial (link right above) before use.

This lithium-ion battery is small, light and durable. Through standard JST 2mm female connector, it will yield 3.7V which will supply your projects for a whole day (and night!). Furthermore, the battery has an implemented protection system, which prevents high voltages ( prevents over-charging), undervoltage and short circuit. That way it protects the battery, increases its lifetime and protects you from possible accidents!

• Nominal voltage: 3.7V
• Capacity: 6000mAh, 22.2Wh
• Dimensions: 90.2 x 60 x 9mm
• Standard JST-PH-2mm connector

DISCLAIMER: This battery has to be charged with a special charged that uses CC/CV principle. Li-ion batteries are dangerous! Read our tutorial (link in the top right corner) before use.

This 5000mah battery is small, light and durable. Through standard JST 2mm female connector, it will yield 3.7V which will supply your projects for a whole day (and night!). Furthermore, the battery has an implemented protection system, which prevents high voltages ( prevents over-charging), undervoltage and short circuit. That way it protects the battery, increases its lifetime and protects you from possible accidents!

• Nominal voltage: 3.7V
• Capacity: 5000mAh, 18.5Wh
• Dimensions: 67.4 x 54.6 x 10.1mm
• Standard JST-PH-2mm connector

DISCLAIMER: This battery has to be charged with a special charged that uses CC/CV principle. Li-ion batteries are dangerous! Read our tutorial (link in the top right corner) before use.

This lithium-ion battery is small, light and durable. Through standard JST 2mm female connector, it will yield 3.7V which will supply your projects for a whole day (and night!). Furthermore, the battery has an implemented protection system, which prevents high voltages ( prevents over-charging), undervoltage and short circuit. That way it protects the battery, increases its lifetime and protects you from possible accidents!

• Nominal voltage: 3.7V
• Capacity: 4000mAh, 14.8Wh
• Dimensions: 81.1 x 50 x 7.7mm
• Standard JST-PH-2mm connector

DISCLAIMER: This battery has to be charged with a special charged that uses CC/CV principle. Li-ion batteries are dangerous! Read our tutorial (link in the top right corner) before use.

This lithium-ion battery is small, light and durable. Through standard JST 2mm female connector, it will yield 3.7V which will supply your projects for a whole day (and night!). Furthermore, the battery has an implemented protection system, which prevents high voltages ( prevents over-charging), undervoltage and short circuit. That way it protects the battery, increases its lifetime and protects you from possible accidents!

• Nominal voltage: 3.7V
• Capacity: 3000mAh, 11.1Wh
• Dimensions: 5.7 x 49.8 x 81.1mm
• Standard JST-PH-2mm connector

DISCLAIMER: This battery has to be charged with a special charged that uses CC/CV principle. Li-ion batteries are dangerous! Read our tutorial (link in the top right corner) before use.

This lithium-ion battery is small, light and durable. Through standard JST 2mm female connector, it will yield 3.7V which will supply your projects for a whole day (and night!). Furthermore, the battery has an implemented protection system, which prevents high voltages ( prevents over-charging), undervoltage and short circuit. That way it protects the battery, increases its lifetime and protects you from possible accidents!

• Nominal voltage: 3.7V
• Capacity: 2100mAh, 7.77Wh
• Dimensions: 9 x 36 x 60mm
• Standard JST-PH-2mm connector

DISCLAIMER: This battery has to be charged with a special charged that uses CC/CV principle. Li-ion batteries are dangerous! Read our tutorial (link in the top right corner) before use.

This lithium-ion battery is small, light and durable. Through standard JST 2mm female connector, it will yield 3.7V which will supply your projects for a whole day (and night!). Furthermore, the battery has an implemented protection system, which prevents high voltages ( prevents over-charging), undervoltage and short circuit. That way it protects the battery, increases its lifetime and protects you from possible accidents!

• Nominal voltage: 3.7V
• Capacity: 1800mAh, 6.66Wh
• Dimensions: 60 x 31.4 x 8mm
• Standard JST-PH-2mm connector

DISCLAIMER: This battery has to be charged with a special charged that uses CC/CV principle. Li-ion batteries are dangerous! Read our tutorial (link in the top right corner) before use.

This 1500mah lithium battery is small, light and durable! Trough standard JST 2mm female connector it will give you normal 3.7V that will power your projects whole day (and night). With all this battery has a built-in system for protection from too high voltage (prevents overcharging), too low voltage and short circuit. That’s how it protects the battery and secures its longer work and protects you from the danger of this battery!

• Nominal voltage: 3.7V
• Capacity: 1500mAh, 5.55Wh
• Dimensions: 47.7 x 29.5 x 9.8mm
• Standard JST-PH-2mm connector

Warning: This battery must be charged with special charger principle CC/CV – like the charger recommended under. Li-ion batteries are dangerous! Read our tutorial (link right above) before use.

This 1200 mah battery is small, light and durable! Through a standard JST 2mm female connector it will give you normal 3.7V that will power your projects whole day (and night). It also has a built-in system for protection from too high a voltage (prevents overcharging), too low a voltage and short circuit. That’s how it protects the battery and ensure a long lasting and safe environment for your projects!

Warning: This battery must be charged with special charger principle CC/CV – like the charger recommended under. Li-ion batteries are dangerous! Read our tutorial (link right above) before use.