Soldering

Soldermask is a layer on a printed circuit board that gives it a color, usually green, and is used to protect the tile from corrosion, easier soldering and visual appearance. This soldermask is in a liquid state, so you can easily apply it to places you want to protect further, such as wires that have been added or lines that have been damaged. It enters the solid state under UV light.

Classic solder for working with a hand soldering iron. Solder paste is in the center of the solder, which simultaneously cleans the surface on which its soldering and gives a better grip of solder.

It is extremely easy to remove insulation and solder with this stranded copper wire. It will serve great in small projects and prototypes.

It is extremely easy to remove insulation and solder with this stranded copper wire. It will serve great in small projects and prototypes.

If the soldering iron isn’t clean, neither will the the solder joint. This cleaning net allows quick tip cleaning by “stabbing” the soldering iron in it. When the net is filled with solder, simply remove it from the casing, clean the excess solder, return it back and use it again!

This is a huge roll of soldering wire. It’s a copper-plated stranded wire that comes in a thickness of 30AWG. Ideal for connecting to a protoboard or inside a project box. If you decide to buy this roll, you’ve probably solved the wire problem for at least 10 years!

• Thickness: 30AWG (0.255mm cross-section)
• Lenght: 250m
• Wire color: crvena, žuta, plava, crna ili bijela
• Stranded copper-plated wire

This small, practical, and portable USB soldering iron powered from PC, laptop, or portable batter is perfect for makers! It works over any USB port and the small tip makes it very precise.  The tip also warms up very quickly, so you can start soldering around 15 seconds after the ignition. Soldering iron comes with a bracket, small amount of solder and a stand.

Of course, be careful while working with soldering iron. Iron’s tip is at temperature is 300-400 degrees Celsius.

• Power: 8W
• Input voltage: 5V
• Length: 16cm

Well known protoboard 2 x 8 cm. Can be used for all of the ongoing mergers and soldering. Very good quality.

Desoldering wick is a very practical tool for every workshop. It’s a braided copper wire, soaked in flux, so it catches solder effectively. If you have a spot from which you need to remove the solder, this strip will do a great job. Unlike the discharge pump, this strip can completely remove the solder from a hole or a pad. 1.5m should last long since you spend only one or two centimeters per one desoldering.

• Lenght: 1.5m
• Width: 1.9mm