Shop

SMD connector for BBC micro:bit board. 40 pins.

easyC system is for easy connection of microcontroller plates, sensors and actuators, which enables rapid prototyping without the possibility of error. The connection between the modules takes place with simple and pre-prepared cables, and easyC modules have connectors that fit the cables. easyC is based on I2C communication.

easyC-compatible cables with easyC connectors on both ends, available in different lengths.

A multimeter is a tool without no electrician can work, but when these little tools appear we ask ourselves what can we do without them! Give this components tester almost anything and it will tell you which component it is and even some more details about it! For example, you connect a resistor on it and it will show it is a resistor and give you his value in ohms. same goes for capacitors and inductors. Give it NPN or PNP transistor it will hFE and Vf. For diodes, it will tell you its voltage drop and capacity. The most interesting is that the tool will know which component is connected.

Classic and simple cutting pliers for cutting off excess material after soldering. Those can also be used for wire cutting or insulation removing.

High-quality spare probes for a multimeter.

If the soldering iron isn’t clean, neither will the the solder joint. This cleaning net allows quick tip cleaning by “stabbing” the soldering iron in it. When the net is filled with solder, simply remove it from the casing, clean the excess solder, return it back and use it again!

Ordinary panel switch (pushbutton). Comes in various colors.

All real machines have an emergency stop button when pressed the whole machine stops. It can be very useful in case of the danger of someone working on that machine. If you want to install a similar thing on your project, here it is!

• Type: DPST
• Maximal voltage: 660V
• Maximal current: 10A
• Button diameter: 40mm
• Mounting hole diameter: 22mm
• Dimensions: 60 x 70mm

443MHz RF is an accessible and affordable standard for RF communication between two devices (e.g. two Dasduino boards or between a remote controller and Dasduino with receiver) often used for remote control, wireless communication and data transmission. With this remote, commands are sent at 433MHz frequency and it’s able to send 4 different commands in total.

443MHz RF is an accessible and affordable standard for RF communication between two devices (e.g. two Dasduino boards or between a remote controller and Dasduino with receiver) often used for remote control, wireless communication and data transmission. This combination allows you to communicate with a remote control that has four buttons with one receiver.

Female header with 2.54mm (0.1 ”) classic pin spacing.

• Distance between pins: 2.54mm(0.1”)
• Number of pins: 8

To pick up ultra-small components and put them in the right place you simply have to own a right tool. One such are the tweezers for SMD components which will enable you to handle 0603 components. With little more exercise even smaller ones, won’t be an issue. Of course, the tweezers are ESD safe so you shouldn’t worry that something will happen to your components.

The SMD components are very small and the tweezers help us to do the job properly. And what should we do when we are having larger components, such as integrated circuits that can be so large that we can not grab them with tweezers? SMD vacuum tweezer will help us here. It uses a vacuum to grab the surface of IC. The vacuum is activated by pressing a small button, so using this tool won’t be a problem. It comes with several tips for different integrated circuits.